Craftmade SE68SPZ Guide d'installation télécharger pdf (Page 9)

page 8

10. Switch Housing Assembly.

fitter

plate

motor

housing

switch

housing

plate

switch housing

male plug

female plug

Remove 3 screws from outer edge of switch

housing plate (save screws for later use).

Remove 1 screw from fitter plate on underside

of motor and partially loosen the other 2

screws. Align slotted holes in center of switch

housing plate with loosened screws in fitter

plate, allowing male plug from motor housing

to come through hole in middle of switch

housing plate. Twist switch housing plate to

lock. Re-insert screw that was removed and

secure all screws.

Connect male plug from motor housing to

female plug from switch housing. Make sure

plugs connect tightly.

Align holes in switch housing with holes in

switch housing plate. Re-insert screws that

were previously removed and use a Phillips

screwdriver to secure all screws.

1 2 3 4 5 6 7 8 9 10 11 12 13

Commentaires sur ces manuels

Pas de commentaire