Craftmade SE68SPZ Guide d'installation télécharger pdf (Page 4)

4. Hanging Bracket Installation.

3. Installation Preparation.

page 3

OFF

Vaulted ceiling

angle is not to

exceed 25 degrees.

downrod

installation

flushmount

installation

12ft. - 20ft.

(3.66m - 6.1m)

7 feet

(2.13m)

(76 cm)

inches

hanging bracket

spring washers

outlet box screws

flat washers

To prevent personal injury and damage, ensure

that the hanging location allows the blades a

clearance of 7 feet (2.13m) from the floor and 30in.

(76cm) from any wall or obstruction.

This fan is suitable for room sizes up to 400 square

feet (37.2 square meters).

This fan can be mounted with a downrod

on a regular (no-slope) or vaulted ceiling. The

hanging length can be extended by purchasing

a longer downrod (0.5in./1.27cm diameter).

Other installation, such as flushmount, is not

available for this fan.

Installation requires these tools:

Phillips screwdriver, flathead screwdriver,

adjustable pliers or wrench, stepladder, wire

cutters and rated electrical tape

blade edge

Turn off circuit breakers to current fixture from breaker panel

and be sure operating light switch is turned to the OFF

position.

WARNING: Failure to disconnect power supply prior to installation

may result in serious injury.

Remove existing fixture.

WARNING: To reduce the risk of fire, electric shock, or personal

injury, mount to outlet box marked "Acceptable for Fan Support of

22.68 kg (50lbs.) or Less" and use mounting screws provided with

the outlet box. Most outlet boxes commonly used for the support

of lighting fixtures are not acceptable for fan support and may

need to be replaced. Consult a qualified electrician if in doubt.

When using an existing outlet box, be sure the box is securely

attached to the building structure and can support the full weight

of the fan. Ensure it is clearly marked "Suitable for Fan Support." If

not, it must be replaced with an approved outlet box. Failure to do

so can result in serious injury.

CAUTION: Be sure outlet box is grounded and that a ground wire

(green or bare) is present.

Install hanging bracket to outlet box using original screws,

spring washers and flat washers provided with new or original

outlet box.* If installing on a vaulted ceiling, face opening of

hanging bracket towards high point of ceiling. Arrange

electrical wiring around the back of the hanging bracket and

away from the bracket opening.

*Note: It is very important that you use the proper hardware when

installing the hanging bracket as this will support the fan.

1 2 3 4 5 6 7 8 9 ... 12 13

Commentaires sur ces manuels

Pas de commentaire

Craftmade SE68SPZ Guide d'installation Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs des ménages Craftmade SE68SPZ