Craftmade CT52 Guide d'installation

Table of Contents:Safety Tips. pg. 1Unpacking Your Fan. pg. 2Parts Inventory. pg. 2Installation Preparation. pg. 3Hanging Bracket Installation. pg. 3F

Troubleshooting.page 11Problem: Fan fails to operate.Solutions:1. Check power to wall switch/wall control.2. Verify that reverse switch is set complet

SAFETY TIPS.page 1WARNING: To reduce the risk of electrical shock, turn off the electricity to the fan at the main fuse box or circuit panel before y

2. Parts Inventory.a. hanging bracket. 1 pieceb. canopy. 1 piecec. 4½in. downrod and hanging ball. 1 pieced. motor housing. 1 piecee. wall control and

4. Hanging Bracket Installation.Turn off circuit breakers to current fixture from breaker panel and be sure operating light switch is turned to the OF

5. Fan Assembly.If you wish to extend the hanging length of your fan, you must remove the hanging ball from the 4½in. downrod provided to use with an

page 55. Fan Assembly. (cont.)With the hanging bracket secured to the outlet box and able to support the fan, you are now ready to hang your fan. Grab

page 6IN ORDER TO WIRE WALL CONTROL, remove existing wall switch. Wire the WALL CONTROL with wire connectors provided as shown in diagram at right.* W

page 8TRANSMITTER(front)9. Light Kit Assembly.molex connectionsglass shademotor housingRemove 1 screw from motor plate on underside of motor housing a

page 10It is recommended that you test fan before finalizing installation. Locate ON/OFF slider switch on wall control and set to the ON position. Tes