Craftmade BW321AG3 Guide d'installation télécharger pdf (Page 8)

page 7

8. Automated Learning Process./

Activating Code.

CAUTION: The remote control transmitter can be

programmed to multiple receivers or fans. If this is

not desired, turn wall switch off to any other

programmable receiver or fan.

Remove battery cover from back side of remote

control transmitter.

Use a ballpoint pen or a small screwdriver to set

the code switches 1 through 4 for the transmitter.

Use the same number sequence used when wiring

the wall control in Section 6 (page 6).

Install 9-volt battery (included) in transmitter.

Re-attach the battery cover after installing battery.

IMPORTANT: To prevent damage to transmitter,

remove the battery if not used for long periods.

Restore electrical power and then set slider switch

on wall control to the ON position. Within 30

seconds of turning on the wall control, press and

hold the "OFF" button on the front of the

transmitter for 5 seconds. Proceed to Section 11 to

verify that the automated learning process is

complete.

TRANSMITTER

(front)

code

switches

pen

TRANSMITTER

(back)

battery

cover

9. Wall Control Operation.

ON/OFF slider switch - turns wall control ON or OFF

HI button - turns lower fan to HIGH speed

MED button - turns lower fan to MEDIUM speed

LOW button - turns lower fan to LOW speed

FAN OFF button - turns lower fan OFF

button - turns main fan ON/OFF when pressed

once (i.e., controls ROTATION of the

ENTIRE fan)

main

fan

lower fan

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire

Craftmade BW321AG3 Guide d'installation Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs des ménages Craftmade BW321AG3